MooseMan
|
Crank for a wilesco d6 - or measurements SORTEDHey all,
Does anyone here happen to have a crank for a D6, or is anyone able to supply me with measurements? Centre to crank pin is really all I need to know.
Thanks,
Moose
|
rangerssteamtoys
|
What is the stroke of the D6? Divide that in 2 and thats your center to crank measurement..
Why do you need to know?
|
Roly Williams
|
Re: Crank for a wilesco d6 - or measurements | MooseMan wrote: | Hey all,
Does anyone here happen to have a crank for a D6, or is anyone able to supply me with measurements? Centre to crank pin is really all I need to know.
Thanks,
Moose |
11mm as near as I can measure with a steel rule (i.e. near enough). Shaft diameter is about 4mm, crank pin diam 3mm, length 55mm.
|
MooseMan
|
I have a D6 minus crank.....not 100% sure of the stroke as the piston doesn't fully utilise the cylinder.
|
rangerssteamtoys
|
Shaft diameter is exactly 4mm, I measured it with a digital caliper.
|
igy569
|
I have a D6 at home, and I would be happy to take measurments with pictures. 
Just let me know....
|
MooseMan
|
Yes please Owen!!!
|
igy569
|
OK. I will do it tonight, and PM you the results. I have a tripod which will help.
|
MooseMan
|
You da man!
Would you be able to take some pics of the steam pipe where it goes into the portface as well?
David Curtis very kindly gave me a "to be restored" D6 when he visited here to pick up his big boat.
|
igy569
|
No problem. I can even post them in the pictures section if other would like to see them. 
|
MooseMan
|
Might as well - you never know who needs them. No rush though mate.
|
superbiker_uk
|
Hi Moose - is this part any good to you? It is an early type D6 crank end that is threaded to take the 4mm crank shaft - you would only need the pully and shaft then. If you want it just PM me your address and I will post it off to you.
|
igy569
|
OK. I posted 12 pictures in the pictures area. I hope they help. If you need any more measurement, just let me know!!
|
