The Unofficial Mamod and Other Steam Forum

ozsteamdemon · Posted: Mon Oct 13, 2008 12:28 am Post subject:

Hi All , I`d love to stay here and browse all your fine collections n that , but i have some serious work to do in the workshop .
I wasn`t gonna work on this project yet , but i might have time to vid a demo b4 our time is up , maybe ?

_________________

Mark-One · Posted: Mon Oct 13, 2008 2:58 am Post subject:

That 20 has to be pulling well in excess of 2000 RPM

_________________

If you can't find the proper tool, use a hammer.

ozsteamdemon · Posted: Mon Oct 13, 2008 4:26 am Post subject:

Mark-One · Posted: Mon Oct 13, 2008 4:33 am Post subject:

You da man

_________________

If you can't find the proper tool, use a hammer.

ozsteamdemon · Posted: Mon Oct 13, 2008 10:15 am Post subject:

I wasn`t particularly interestered in the speed , its the torque i want to know about . The unloaded high speed run i did was a performance trial . Now its time for the Torque trials to begin .
My Gas burner has a problem and not working properly , causing the steam pressure and recovery to be weak , so i`ll get one like Clintons for next time .

_________________

ozsteamdemon · Posted: Mon Oct 13, 2008 10:51 am Post subject:

Hi All , this is final post on my table i think . As i thought my table should be of wholly new pics and vids taken since Friday , i`ve been really busy working hard to get my projects runable , that i spent every day in my workshop making steam fittings and bits and pieces and then spending all nite on the darn fangled puter that wont do what i wanted it to do . so this next pic is the only old pic that i posted this weekend ....... not bad for old age puter dummy i reckon .
This pic some of you may have seen b4 but i`m posting it again because it was the first engine casting kit that i machined , but i dont have it atm cos i lent it to my Club and i havent go it back yet , but if i did i would have steamed it also .

_________________